Lincoln Navigator: Climate Control System - General Information / Driver Side Register Air Discharge Temperature Sensor. Removal and Installation
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the sunload sensor and disconnect the electrical connector.
Use the General Equipment: Interior Trim Remover
-
Release the clips and remove the instrument panel center speaker grille.
Use the General Equipment: Interior Trim Remover
-
Remove the screws and position the instrument panel center speaker up.
Torque:
22 lb.in (2.5 Nm)
-
Disconnect the electrical connector and remove the instrument panel center speaker.
-
Disconnect the electrical connector and remove the driver side register air discharge temperature sensor.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Detach the clips and remove the lower steering column opening cover...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation)...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation...
Special Tool(s) /
General Equipment
292-00004Fuel Tanker 100 GPM
Activation
Disconnect the battery ground cable.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures)...