Lincoln Navigator: Glass, Frames and Mechanisms / Front Door Glass Run and Bracket. Removal and Installation
Removal
NOTE:
LH side shown, RH side similar.
-
Remove the front door latch.
Refer to: Front Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
-
Remove the exterior front door handle reinforcement.
-
Detach the cable from the exterior front door handle reinforcement.
-
Remove the cable eyelet from the lever.
-
Remove the cable from the routing clip.
-
Press the locking tab down.
-
If equipped, disconnect the door lock cylinder rod.
Remove the exterior front door handle reinforcement.
-
Remove the front door glass run and bracket.
-
Release the retaining tabs on the front door glass run and bracket.
-
Remove the front door glass run and bracket.
Installation
-
To install, reverse the removal procedure.
-
Carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Removal
Remove the driver door trim panel.
Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front door window regulator and motor...
Other information:
BLIS ®
The BLIS
® aids the driver in assessing whether another vehicle is present
within a specific area (blind spot) to either side of the vehicle while
driving on roads and highways. The system is not designed to prevent
contact with other vehicles or objects...
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully. Do not place any objects between the seat components
and the body of the vehicle, nor any objects within a joint internal to
the seat structure...