Lincoln Navigator: Electronic Engine Controls - 3.5L EcoBoost (272kW/370PS) / Manifold Absolute Pressure and Temperature (MAPT) Sensor. Removal and Installation
Removal
-
Remove the engine appearance cover retainers, release
the engine appearance cover from the rear retainers and then remove the
engine appearance cover.
-
-
Disconnect the MAPT electrical connector.
-
Remove the bolt and the MAPT sensor
Installation
-
NOTE:
Lubricate the O-ring seal with clean engine oil.
-
Install the MAPT sensor and the bolt.
Torque:
27 lb.in (3 Nm)
-
Connect the MAPT electrical connector.
-
Install the engine appearance cover and retainers.
Torque:
97 lb.in (11 Nm)
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the direct injection fuel rail LH and RH side...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the engine front cover.
Refer to: Engine Front Cover (303-01 Engine - 3...
Other information:
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTICE:
The turbocharger compressor vanes can be damaged by even the
smallest particles. When removing any turbocharger or engine air intake
system component, ensure that no debris enters the system...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Left hand (LH) shown, right hand (RH) similar.
NOTE:
Removal steps in this procedure may contain installation details.
Position the rear door weatherstrip aside...