Lincoln Navigator: Engine System - General Information / Crankshaft Main Bearing Journal Clearance. General Procedures
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
-
NOTE:
Crankshaft main bearing journals must be within specifications before checking journal clearance.
Remove the crankshaft main bearing cap and crankshaft main bearing.
-
Position a piece of Plastigage across the crankshaft main bearing surface.
-
NOTE:
Do not turn the crankshaft while carrying out this procedure.
Install and tighten to specifications, then remove the crankshaft main bearing cap.
-
Measure the Plastigage to get the crankshaft main
bearing clearance. The Plastigage should be smooth and flat. A changing
width indicates a tapered or damaged crankshaft or crankshaft bearing.
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
The crankshaft connecting rod journals must be
within specifications to check the connecting rod bearing journal
clearance...
Special Tool(s) /
General Equipment
100-001
(T50T-100-A)
Slide Hammer
Materials
Name
Specification
Motorcraft® Threadlock 262TA-26
WSK-M2G351-A6
Repair
All core plugs
NOTE:
Cylinder block core plug shown, cylinder head core plug similar...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
ATCM
U0140:00
Lost Communication With Body Control Module: No Sub Type Information
GO to Pinpoint Test C
..
Introduction
WARNING:
Before beginning any service procedure in this manual, refer
to health and safety warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury.
For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
This
manual ..