Lincoln Navigator: Engine Emission Control - 3.5L EcoBoost (272kW/370PS) / Exhaust Gas Recirculation (EGR) Back Pressure Sensor. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the engine appearance cover retainers, release
the engine appearance cover from the rear retainers and then remove the
engine appearance cover.
-
Remove the RH side air cleaner outlet pipe.
Refer to: Air Cleaner Outlet Pipe RH (303-12 Intake Air Distribution
and Filtering - 3.5L EcoBoost (272kW/370PS), Removal and Installation).
-
Remove the RH side CAC intake pipe.
Refer to: Charge Air Cooler (CAC) Intake Pipe (303-12 Intake Air
Distribution and Filtering - 3.5L EcoBoost (272kW/370PS), Removal and
Installation).
-
Disconnect the EGR back pressure sensor electrical connector.
-
Remove the EGR back pressure sensor.
Torque:
97 lb.in (11 Nm)
Installation
-
Lubricate the o-ring seal with clean engine oil. Replace the o-ring if necessary.
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the engine appearance cover retainers, release
the engine appearance cover from the rear retainers and then remove the
engine appearance cover...
Removal
Remove the engine appearance cover retainers, release
the engine appearance cover from the rear retainers and then remove the
engine appearance cover...
Other information:
Removal
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Open the liftgate window glass.
Remove the liftgate window latch...
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front door window regulator and motor.
Refer to: Front Door Window Regulator and Motor (501-11 Glass, Frames and Mechanisms, Removal and Installation)...