Lincoln Navigator: Exterior Lighting / Front Fog Lamp. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH (left-hand) front fog lamp shown, RH (right-hand) front fog lamp similar.
-
Remove the front wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
-
Remove the fender liner screws.
Torque:
18 lb.in (2 Nm)
-
Remove the screws, the push pins and position the fender liner aside.
Torque:
18 lb.in (2 Nm)
-
Remove the bolts and the front fog lamp assembly.
-
Disconnect the electrical connector and harness retainer.
Installation
-
To install, reverse the the removal procedure.
-
Adjust the fog lamp.
Refer to: Front Fog Lamp Adjustment (417-01 Exterior Lighting, General Procedures).
Adjustment
NOTE:
If the flash video link does not load or is
incompatible with your browser, a .wmv version of the video can be
accessed at:
http://www...
Removal
NOTE:
LH (left-hand) front turn signal lamp shown, RH (right-hand) front turn signal lamp similar.
Remove the front bumper cover...
Other information:
Special Tool(s) /
General Equipment
Crimping Tool
Materials
Name
Specification
Motorcraft® Premium Long-Life GreaseXG-1-E1
ESA-M1C75-B
Removal
With the vehicle in NEUTRAL, position the vehicle on a hoist...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
WARNING:
Disconnect the 12 volt battery before servicing the direct
current to alternating current (DC-AC) inverter or alternating current
(AC) powerpoint to prevent the risk of high voltage shock...