Lincoln Navigator: Information and Entertainment System - General Information - Vehicles With: SYNC 4 / SYNC Module [APIM] to Universal Serial Bus (USB) Port Cable. Removal and Installation
Special Tool(s) /
General Equipment
Removal
Upper USB cable
-
Remove the ACM .
Refer to: Audio Front Control Module (ACM) (415-00 Information and
Entertainment System - General Information - Vehicles With: SYNC 4,
Removal and Installation).
-
Disconnect the USB cable connection.
-
Release the clips and remove the LH floor console side trim panel.
Use the General Equipment: Interior Trim Remover
-
Disconnect the USB connector.
-
Separate the cable guides and remove the upper USB cable.
Lower USB cable
-
Release the clips and remove the front floor console trim panel.
Use the General Equipment: Interior Trim Remover
-
Remove the bolts.
-
Position the floor console armrest.
-
On both sides
Release the clips and remove the floor console finish panel.
Use the General Equipment: Interior Trim Remover
-
On both sides
Release the clips and remove the floor console side trim panel.
Use the General Equipment: Interior Trim Remover
-
Position the floor console armrest.
-
Remove the front upper console trim panel screws.
-
Remove the upper console trim panel.
-
On both sides.
Remove the screws.
-
On both sides.
Release the clips.
-
Disconnect the electrical connectors and separate the wire harness guide.
-
Remove the screws, disconnect the electrical
connectors, separate the wire harness guides and remove the console top
plate.
-
Disconnect the USB connector.
-
Separate the USB cable guides and remove the USB cable.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to upload the
module configuration information to the scan tool prior to removing the
module...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the IAT sensor electrical connector.
Remove the IAT sensor.
Installation
To install, reverse the removal procedure...
Special Tool(s) /
General Equipment
307-746Remover, Transmission Wiring Harness Connector
Removal
Remove the main control valve body.
Refer to: Main Control Valve Body (307-01 Automatic Transmission -
10-Speed Automatic Transmission – 10R80, Removal and Installation)...