Lincoln Navigator: Seatbelt Systems / Third Row Seatbelt Retractor - Long Wheelbase. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
RH shown, LH similar.
-
Remove the load space trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the bolt and the third row seatbelt retractor.
Torque:
30 lb.ft (40 Nm)
Installation
NOTE:
During installation, make sure the seatbelt webbing is not
twisted and the seatbelts and buckles are accessible to the occupants.
-
To install, reverse the removal procedure.
-
Check the seatbelt system for correct operation.
Refer to: Seatbelt System Functional Tests (501-20A Seatbelt Systems, General Procedures).
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Position the liftgate opening weatherstrip aside...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
RH shown, LH similar.
Remove the loadspace trim panel...
Other information:
Special Tool(s) /
General Equipment
303-1655Tool, Camshaft Holding
Removal
NOTICE:
During engine repair procedures, cleanliness is extremely
important. Any foreign material, including any material created while
cleaning gasket surfaces, that enters the oil passages, coolant passages
or the oil pan may cause engine failure...
Overview
The 4WD front suspension consists of the following components:
Lower ball joints
Lower control arms
Ride height sensors (Vehicles with Continuously Controlled Damping (CCD) Suspension)
Stabilizer bar, bushings and links
Shock absorber and coil spring assemblies
Upper control arms
Wheel bearing and wheel hubs
Wheel kn..