Lincoln Navigator: Glass, Frames and Mechanisms / Rear Door Window Regulator and Motor. Removal and Installation
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
For non-functional rear door window regulators and motors
with the window in the 40 mm open to full closed position, cut the rear
door window regulator cables to allow window movement.
-
Remove the rear door window glass.
Refer to: Rear Door Window Glass (501-11 Glass, Frames and Mechanisms, Removal and Installation).
-
Remove the rear door window regulator and motor.
-
Disconnect the rear door window regulator motor wiring harness electrical connector.
-
Remove the rear door window regulator and motor nuts.
Torque:
93 lb.in (10.5 Nm)
-
Remove the rear door window regulator and motor.
-
NOTE:
This step is only necessary when installing a new component.
Remove the rear door window regulator motor.
-
Remove the rear door window regulator motor bolts.
-
Remove the rear door window regulator motor.
Installation
-
To install, reverse the removal procedure.
-
Carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
For non-functional rear door window regulators and motors
with the window in the 40 mm open to full closed position, cut the rear
door window regulator cables to allow window movement...
Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Make sure all cylinder head surfaces are clear of
any gasket material, silicone sealant, oil and coolant. The cylinder
head surface must be clean and dry before running a flatness check.
NOTE:
Use a Straightedge th..
Special Tool(s) /
General Equipment
6.5 mm Drill Bit
Spherical Cutter
Polydrive Bit Socket
Self-Piercing Rivet (SPR) Remover/Installer
Belt Sander
Blind Rivet Gun
Hot Air Gun
Air Body Saw
MIG/MAG Welding Equipment
Locking Pliers
Materials
Name
Specification
Metal Bonding AdhesiveTA-1, TA-1-B, 3M..