Lincoln Navigator: Second Row Seats / Second Row Seat Backrest Blower Motor. Removal and Installation
Special Tool(s) /
General Equipment
Removal
NOTE:
Right hand (RH) shown, left hand (LH) similar.
-
Remove the second row single seat backrest cover.
Refer to: Second Row Single Seat Backrest Cover - Vehicles Without:
Multi-Contour Seats (501-10B Second Row Seats, Removal and
Installation).
Refer to: Second Row Single Seat Backrest Cover - Vehicles With:
Multi-Contour Seats (501-10B Second Row Seats, Removal and
Installation).
-
Remove the second row seat backrest blower motor.
-
Release the second row seat backrest blower motor J-clip and straps.
-
Release the second row seat backrest blower motor tabs.
Use the General Equipment: Interior Trim Remover
Installation
-
To install, reverse the removal procedure.
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully...
Removal
NOTE:
Right hand (RH) shown, left hand (LH) similar.
Remove the second row seat.
Refer to: Second Row Seat (501-10B Second Row Seats, Removal and Installation)...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the sunload sensor and disconnect the electrical connector.
Use the General Equipment: Interior Trim Remover
Release the clips and remove the instrument panel c..
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
GWM
U0001:09
High Speed CAN Communication Bus: Component Failures
GO to Pinpoint Test AW
GWM
U02..