Lincoln Navigator: Transfer Case / Specifications
| Item | Fill Capacity |
| Material: Motorcraft® MERCON® LV Automatic Transmission Fluid / XT-10-QLVC (WSS-M2C938-A) (MERCON® LV, ) | 1.4L (2.9 pt) |
Transfer Case - Overview. Description and Operation
Two-Speed Torque-On-Demand
The 2-speed torque-on-demand transfer case consists of the following components:
Mode Select Switch (MSS)
Transfer Case Control Module (TCCM)
Transfer case shift motor
The
Borg-Warner 2-speed torque-on-demand transfer case is a 2-piece
magnesium design...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Quick Release Coupling. General Procedures
Disconnect NOTICE: When reusing liquid or vapor tube connections, make sure to use compressed air to remove any foreign material from the connector retaining clip area before separating from the tube or damage to the tube or connector retaining clip may occur...
Lincoln Navigator 2018-2026 Workshop Manual: Rear Halfshaft Seal. Removal and Installation
Special Tool(s) / General Equipment 205-907Handle, 32 DriverTKIT-2008DH-FLM 206-034 (T88P-20202-B) Installer, Wheel Speed Sensor RingTKIT-1988-FLMTKIT-1988-LM Feeler Gauge Removal NOTE: Removal steps in this procedure may contain installation details...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Remote Function Actuator (RFA) Module. Removal and Installation
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Transmission Fluid Drain and Refill. General Procedures
- Identification Codes. Description and Operation
- Telematics Control Unit (TCU) Module. Removal and Installation
Diagnostic Methods. Description and Operation
This document provides critical diagnostic knowledge required for successful repair outcomes. It identifies technical competencies expected by users of this manual.
Ford Diagnostic Assumptions
Ford diagnostics assume the vehicle concern described by the test title is currently present. Exceptions to this rule are noted in each test. Do not replace modules or other components as directed by a diagnostic if the concern is not present at the time of testing.
