Lincoln Navigator: Automatic Transmission - 10-Speed Automatic Transmission – 10R80 / Transmission Fluid Exchange. General Procedures
Special Tool(s) /
General Equipment
Materials
Name |
Specification |
Motorcraft® MERCON® ULV Automatic Transmission Fluid XT-12-QULV |
WSS-M2C949-A, MERCON® ULV
|
Connect
NOTICE:
Use transmission fluid specific for this transmission. Do
not use any supplemental transmission fluid additives or cleaning
agents. The use of these products can cause internal transmission
components to fail, which will affect the operation of the transmission.
-
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
-
Connect the Fluid Exchanger to the transmission fluid
cooler tube after the transmission fluid cooler on the return tube. This
helps remove any foreign material trapped in the transmission fluid
coolers.
Use the General Equipment: Fluid Exchanger
-
Perform the transmission fluid exchange using the Fluid Exchanger.
-
Follow the manufacturer's instructions included with the machine.
Use the General Equipment: Fluid Exchanger
Material: Motorcraft® MERCON® ULV Automatic Transmission Fluid
/ XT-12-QULV
(WSS-M2C949-A, )
(MERCON® ULV)
-
Once the transmission fluid exchange is completed,
disconnect the Fluid Exchanger. Reconnect any disconnected transmission
fluid cooler tubes.
Use the General Equipment: Fluid Exchanger
-
Check the transmission fluid level.
Refer to: Transmission Fluid Level Check (307-01 Automatic Transmission
- 10-Speed Automatic Transmission – 10R80, General Procedures).
Special Tool(s) /
General Equipment
Fluid Suction Gun
Universal Fluid Dispenser
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
Draining
NOTE:
It is not necessary to remove the transmission fluid filter to drain the transmission fluid...
Check
NOTICE:
The vehicle should not be driven if the transmission fluid level is low. Internal failure could result.
NOTE:
If the vehicle has been operated for an extended period at
high highway speeds, in city traffic, during hot weather or while
pulling a trailer, the transmission fluid must cool down to obtain an
accurate reading...
Other information:
Removal
NOTICE:
Make sure that all openings are sealed.
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
NOTE:
Removal steps in this procedure may contain installation details...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).
Disconnect the rear parking aid sensor electrical connectors...