Lincoln Navigator: Voltage Converter/Inverter / Direct Current/Direct Current (DC/DC) Converter Control Module. Removal and Installation
Removal
-
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
Upload the Direct Current/Direct Current (DC/DC)
configuration to the scan tool by following the scan tool on-screen
instructions.
-
Position the RH front seat rearward.
-
Remove the retainers and lower the RH lower dash panel.
-
Disconnect the Direct Current/Direct Current (DC/DC)
converter control module electrical connector. Remove the retainers and
the DC/DC converter control module.
Installation
-
To install, reverse the removal procedure.
-
If replacing the module, download the Direct
Current/Direct Current (DC/DC) converter control module configuration
information from the scan tool to the new Direct Current/Direct Current
(DC/DC) converter control module following the scan tool on-screen
instructions.
Removal
WARNING:
Disconnect the 12 volt battery before servicing the direct
current to alternating current (DC-AC) inverter or alternating current
(AC) powerpoint to prevent the risk of high voltage shock...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
For non-functional front door window regulators and motors
with the window in the 40 mm open to full closed position, cut the front
door window regulator cables to allow window movement.
NOTE:
Removal steps in this procedure may contain instal..
Materials
Name
Specification
Engine Oil - SAE 5W-30 - Synthetic Blend Motor OilXO-5W30-Q1SP
WSS-M2C946-B1
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the engine appearance cover retainers, release
the engine appearance cover from the rear retainers and then remove the
engine appearance co..