Lincoln Navigator: Engine / Engine Cooling - 3.5L EcoBoost (272kW/370PS)
- Specifications
- Engine Cooling - Component Location. Description and Operation
- Engine Cooling - System Operation and Component Description. Description and Operation
- Cooling Fan Control. Diagnosis and Testing
- Engine Cooling. Diagnosis and Testing
- Engine Temperature. Diagnosis and Testing
- Engine Cooling System Draining, Vacuum Filling and Bleeding. General Procedures
- Engine Cooling System Flushing. General Procedures
- Block Heater. Removal and Installation
- Coolant Pump. Removal and Installation
- Cooling Fan Motor and Shroud. Removal and Installation
- Cooling Module. Removal and Installation
- Degas Bottle. Removal and Installation
- Radiator. Removal and Installation
- Thermostat. Removal and Installation
- Thermostat Housing. Removal and Installation
- Transmission Fluid Heater Coolant Control Valve. Removal and Installation
Specifications
Coolant Capacity: Vehicles Built Up To: 08-July-2018
Name
Fill Capacity
Material: Motorcraft® Orange Concentrated Antifreeze/Coolant
/ VC-3-B
(WSS-M97B44-D)
Base radiator — 18...
Other information:
Lincoln Navigator 2018-2025 Workshop Manual: Rear Door Moulding. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: SWB (Short wheel base) shown, LWB (Long wheel base) similar. NOTE: LH side shown, RH side similar. NOTICE: To avoid damage to moulding, only use moderate force...
Lincoln Navigator 2018-2025 Workshop Manual: Rear Door Glass Run and Bracket. Removal and Installation
Removal NOTE: LH side shown, RH side similar. NOTE: Removal steps in this procedure may contain installation details. Aft rear door glass run and bracket Remove the rear door trim panel. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2025)
- Remote Function Actuator (RFA) Module. Removal and Installation
- Brake Service Mode Activation and Deactivation. General Procedures
- All Terrain Control Module (ATCM). Removal and Installation
- Identification Codes. Description and Operation
- Satellite Radio Antenna. Removal and Installation
Differential Case Runout Check. General Procedures
Special Tool(s) / General Equipment
205-1016Installer, Differential Bearing
TKIT-2014D-ROW2
TKIT-2014D-FL_ROW
205-153
(T80T-4000-W)
Handle
205-D061
(D83T-4205-C2)
Step Plate Dial Indicator Three Leg Puller Punch
