Lincoln Navigator: Electronic Feature Group / Multifunction Electronic Modules
- Module Controlled Functions - Component Location. Description and Operation
- Module Controlled Functions - Overview. Description and Operation
- Module Controlled Functions - System Operation and Component Description. Description and Operation
- Body Control Module (BCM). Diagnosis and Testing
- Body Control Module C (BCMC). Diagnosis and Testing
- Factory Mode Deactivation. General Procedures
- Transport Mode Deactivation. General Procedures
- Body Control Module (BCM). Removal and Installation
- Body Control Module C (BCMC). Removal and Installation
- Driver Door Module (DDM). Removal and Installation
- Passenger Door Module (PDM). Removal and Installation
- Radio Transceiver Module (RTM). Removal and Installation
Image Processing Module A (IPMA) Camera. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rain sensor cover.
Disconnect the IPMA camera electrical connector...
Module Controlled Functions - Component Location. Description and Operation
Item
Description
1
BCMC
2
BCM
3
PDM
4
RTM
5
DDM
..
Other information:
Lincoln Navigator 2018-2025 Workshop Manual: Evaporative Emission Blocking Valve. Removal and Installation
Removal Remove the fuel tank. Refer to: Fuel Tank (310-01 Fuel Tank and Lines - 3.5L EcoBoost (272kW/370PS), Removal and Installation). Disconnect the EVAP quick connect coupling. Refer to: Quick Release Coupling (310-00) . Release the hose routing clips and remove the EVAP blocking valve. ..
Lincoln Navigator 2018-2025 Workshop Manual: Spark Plugs. Removal and Installation
Removal Remove the ignition coil-on-plugs. Refer to: Ignition Coil-On-Plug (303-07 Engine Ignition - 3.5L EcoBoost (272kW/370PS), Removal and Installation). Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs. NOTICE: Do not remove the spark plugs when the engine is hot or col..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2025)
- Body Control Module (BCM). Removal and Installation
- Body and Paint
- Liftgate Trim Panel. Removal and Installation
- Rear Suspension Height Sensor. Removal and Installation
- SYNC Module [APIM]. Removal and Installation
Rear Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH.
